McCulloch 532 43 21-09 Benutzerhandbuch

IMPORTANT: 

WHEN UNPACKING AND AS SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK 

CABLE(S).

•  Cut cable ties securing handle column.
•.  Route cable(s) as shown and slide handle column onto 

handle mount.

•  Remove all packing from carton.
• 

Secure handle column using two (2) carriage bolts and 

two (2) flange locknuts. Tighten se cure ly.

•  Cut away carton.
•  Route tine control cable(s) through plas tic cable clip 

on handle mount.

NOTE: Cables must not touch the muffler.
• 

Cut cable ties securing tiller to skid. Re move tiller from 

skid by pulling backwards. 

•  Remove screws securing depth stake to skid and 

discard the screws.  

dep

th_st

ak

e_4

• 

Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just -

ments section of this manual).

•  Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 

Service and Adjustments section of this manual).

• 

Check tine operation before first use.  (See “TINE OP-

ERATION CHECK” in the Service and Adjustments 

section of this manual). 

•  Loosen nut “A”.
•  Insert stake support between engine brack et halves 

with stake spring down. 

•  Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tight en se curely. Tighten nut “A”.

•  Depth stake must move freely. If it does not, loosen 

support bolt.