Nilfisk Alto 05230F Benutzerhandbuch

   Operator's Manual - SCRUBTEC 770 / 784 / 795

B

A

How to Operate the One Touch System (“L Class” models only) 
One touch cleaning is a feature on the new Scrubtec Walk-behind 
Scrubber.  The factory defaults for this setting are two bars of brush 
pressure and four bars for solution fl ow and squeegee in the down 
position.
1.  Press and release the green button for all cleaning functions to 

begin, see fi gure #11, item A.

2.  The squeegee and brush head lower to the fl oor and the 

vacuum starts.  NOTE: The squeegee switch must be in the 
center position for the squeegee to operate with the one touch 
feature, see fi gure #11, item B.

3.  The brushes and solution will begin only when you begin to 

traverse.

4.  The cleaning will be at the factory default settings, however  

you can reprogram these settings to your specifi cations.  See 
“Reprogramming One Touch” section below.

5.  To end cleaning process, press the green button again 

and solution will stop; brushes will raise; after a short delay 
squeegee will raise; and the motor will turn off.

NOTE: It is intended that this be done while traversing.  If you 
stop and do it, some solution can be left on the fl oor.
Reprogramming One Touch
If you do not want to use the factory default settings, you may
reprogram the setting by following the procedures below:
1.  Place the machine in the desired scrub condition by using the 

one touch and individual switches.

2.  Press and hold the green one touch button until you see the 

LCD display fl ash, then release the button.  NOTE:  The time 
required should be approximately 5 seconds.

3.  When you activate or deactivate the one touch, it will now be 

set to your preference for cleaning.  These settings will remain 
until you disconnect power or reprogram them.  NOTE: When 
programming one touch, be sure squeegee is in automatic 
(middle) position, otherwise you may program squeegee either 
up or down all the time.

How to Return One Touch to Factory Default Settings
To restore the factory settings, follow the procedures below:
1.  Press and hold the green one touch button until you see the 

LCD display fl ash two times (5 seconds between fl ashes), 
see fi gure 11.  NOTE:  The time required for this will be 
approximately 10 seconds.

2.  The settings should be returned to 4 bars of solution and 2 bars 

of brush pressure.  NOTE:  The squeegee vac switch must be 
in the middle position for default settings to work.