Weber 2 Benutzerhandbuch
Genesis
™
Side Burner
Accessory Installation
Step 1
몇
WARNING: All gas controls and supply valves
should be in the OFF position.
You will need: Side burner assembly (includes burner
grate), side burner lock, pipe sealant (suitable for natural
or LP gas), 1/4, 7/16, 5/8, 3/4 and 11/16 inch open-end or
two adjustable wrenches.
grate), side burner lock, pipe sealant (suitable for natural
or LP gas), 1/4, 7/16, 5/8, 3/4 and 11/16 inch open-end or
two adjustable wrenches.
Step 2
Genesis 2 and 2000 Models:
Remove the right side work table, burner control knobs
and control panel.
and control panel.
Genesis 4 Models:
Remove the right side work table, serving tray, burner
control knobs, FlameCheck Safety button and control panel.
control knobs, FlameCheck Safety button and control panel.
For use with Genesis Gas Barbecues Only
27-4736910 3/98
Step 3
Note: Your owner’s manual may reflect installing only
one side burner lock. If it does, please ignore and
follow this installation procedure for two side burner
locks.
one side burner lock. If it does, please ignore and
follow this installation procedure for two side burner
locks.
You will need: frame assembly, two side burner locks and
a 7/16 inch wrench.
a 7/16 inch wrench.
Loosen the right rear 1/4 x 20 bolt. Install the side burner
lock. The “U” shape cut out of the lock slips down over the
bolt. Tighten with a wrench. Figure 1 (a).
lock. The “U” shape cut out of the lock slips down over the
bolt. Tighten with a wrench. Figure 1 (a).
Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. The “U” shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 1 (b).
fits between the front panel and the frame. The “U” shape
cut out slips up over the bolt. Tighten with a wrench.
Figure 1 (b).
Figure 1
(a)
(b)
Follow the remainder of assembly steps in your Owners
Manual.
Manual.