SVAT Electronics CLEARVU11 Benutzerhandbuch

now you can see

CLEARVU11

24

The general operations are as below:

•

▲▼◄►- Press these buttons to select the items. The display will scroll left/right if the selected item is not  

  shown on the screen.
•  Numeric (CH1-CH4) - Press these buttons to select the camera.

•  COPY (   ) - Press this button to copy all the settings - excluding detailed Motion settings, Video Loss 

settings, Title/Audio - of the focus camera to all the following cameras. (E.g. focus camera is 1, its settings will 

be copied to those of cameras 2-4.)

•  ESC (MENU/ESC) - Press this button to escape from this screen, and return to Setup Menu display. If the Save 

dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.

In Setup Menu display, press 

▲▼ 

to change the highlighted option 

to Alarm, and then press ENTER 

to call up Alarm Setup display as 

shown. The Alarm Setup allows 

the administrator to define the 

attributes for each alarm input, and 

the actions if it’s triggered. There 

are up to 4 alarm inputs which can 

be connected to the system.

Following is a brief description for each item and its specific operations:

•  Normal State – press +/- buttons to select N/A, Close or Open. Please check the signal type, normally close or 

normally open, connected to the alarm input terminal on the rear panel of the system. If there’s no signal connected, 

please select N/A – Not Available, and the following items will not be setup. The default setting is Open.

•  Focus Camera – the camera corresponding to this alarm input.

•  Duration – response duration to define  how long (in seconds) the Alarm Out relay and the Buzzer will stay on for 

after this alarm input is triggered. However, the Alarm Out relay and the Buzzer will be reset immediately once this 

alarm input returns to normal. Press +/- buttons to adjust the value (3-60 seconds, discrete).

•  Goto Preset – to define the preset position to go to for the Focus Camera if this alarm input is triggered (only 

available for PTZ cameras). 

•  Pre-record – to define how long before this alarm input is triggered the Focus Camera will be recorded at pre-

record IPS. Press +/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record 

time may be shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buffer size 

of the system.