Hitachi DZ-GX5080A Benutzerhandbuch

Seite von 158
English
60
Setting Up Record Functions
1<>2/
SWITCHING MOVIE QUALITY (VIDEO MODE)
Choose the movie quality from “XTRA”, “FINE”, “STD”.
1
Press the MENU button, use the f/e/
d/c/A buttons to choose “VIDEO 
Mode” on the “Record Functions Setup” 
menu screen, and then press the A button.
2
Choose the desired quality mode, and then 
press the A button.
3
Press the MENU button to end the setting.
Note
:
• The movie quality setting will be stored in memory 
even when the DVD video camera/recorder is turned 
off.
• When using a DVD-RW (VF-mode)/DVD-R disc, the 
“VIDEO Mode” setting will not change even if the disc 
is replaced.
• When using DVD-RW (VF-mode)/DVD-R disc, you 
cannot switch the setting on movie quality or wide-
screen mode while recording on the disc: The DVD 
video camera/recorder will be automatically set to the 
movie quality or wide-screen mode first used with the 
disc for recording.
• When using a DVD-RW (VF-mode)/DVD-R/+RW:
You cannot specify the combination of “VIDEO Mode: 
STD” and “16:9 On”. If you specify “16:9 On” and try 
to switch the VIDEO Mode to STD from XTRA or 
FINE, the screen will automatically switch to the 4:3-
aspect ratio display.
• The movie quality setting is effective only during 
movie recording: The setting will not be displayed 
during recording of stills.
Block-like noise may appear in recorded image, or the outline of subject image is distorted under the 
recording conditions listed below. Pan the DVD video camera/recorder as slowly as possible. (Block 
noise is likely to appear in the “STD” mode):
If there is a complicated pattern in background (as in following figure on left);
If the DVD video camera/recorder is moved excessively or quickly;
If subject is moving rapidly even when the DVD video camera/recorder is not moving.
It is recommended that you record critical subjects in the “XTRA” or “FINE” mode.
(Image when block-like noise occurs)
(Image without block-like noise)