Pelco FR85041 Benutzerhandbuch

 

16

C1645M-A (9/06)

 

The FT85041 transmitter/FR85041 receiver can be mounted into a rack or can be used as a stand-
alone module. As a stand-alone module, the unit can be placed on a desktop or can be mounted to a 
wall.

 

As a matter of convenience, it is recommended that you set the desired data communication 

before mounting the FT85041 transmitter/FR85041 receiver. To set the desired data communication, 
refer to the 

 

 section.

 

The FT85041 transmitter/FR85041 receiver can be installed into an RK5000 Series rack mount 
chassis, which can be mounted into an industry-standard 19-inch (48.26 cm) equipment rack. 
The RK5000 Series rack mount chassis includes the following models:

 

•

 

Designed to accommodate fiber optic modules as follows:

 

–

 

The RK5000PS-3U rack mount chassis provides 12 single-width module slots and a 
power supply. 

 

–

 

The RK5000-3U rack mount chassis provides 14 single-width module slots (a power 
supply is not included). Power to the modules can be supplied using the optional external 
power supply (EPS5000-120).

For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis 
Installation manual.

 

•

 

Designed to accommodate Endura

 

™

 

 modules but can also accommodate fiber 

optic modules with the use of the appropriate adapter kit. The RK5002-1UEXP adapter kit is 
required for installation of the FT85041 transmitter/FR85041 receiver into the RK5000PS- 5U 
chassis.

For information about the RK5000PS-5U chassis, refer to the RK5000PS-5U Rack Mount Chassis 
Installation manual. 

 

The FT85041 transmitter/FR85041 receiver is a double-width fiber optic module that 

occupies two slots in the RK5000PS-3U, RK5000-3U, and RK5000PS-5U chassis.

 

The FT85041 transmitter/FR85041 receiver can be mounted to a wall in the following ways:

 

•

 

Using the supplied wall clip for attachment of a single module to a wall. For installation 
instructions, refer to the 

 

 section.

 

•

 

Using the optional WM5002 wall mount kits, which are designed for mounting of double-
width fiber optic modules. The WM5002-3U base kit allows mounting of a single module to a 
wall. The WM5002-3UEXP expansion kit allows mounting of an additional module. It is 
recommended that a maximum of one expansion kit be used with the base kit, allowing a 
maximum of two double-width modules to be mounted to a wall.

NOTE: The WM5002 wall mount kits can be used with the WM5001 wall mount kits, which 
are designed for mounting of single-width fiber optic modules. If mounting a mix of single-width 
and double-width modules is desired, it is recommended that a maximum of two single-width 
modules and one double-width module be mounted in combination with one another.

For mounting instructions using the wall mount kits, refer to the WM5000 Series W all Mount 
Kit Installation manual. 

C1645M-A.book  Page 16  Wednesday, September 13, 2006  3:07 PM