Panasonic NV-GS25GN Benutzerhandbuch

Seite von 56
Before using
9
LSQT0893
≥The recordable time will become shorter in the 
following cases:
≥When you use both the viewfinder and the 
LCD monitor simultaneously while rotating 
the LCD monitor frontward to record yourself 
etc.
≥The batteries heat up after use or charging. The 
main unit of the movie camera being used will 
also heat up. This is normal.
≥Along with the reduction of the battery capacity, 
the display will change: 
# s # 
# u # v. If the battery 
discharges, then 
u (v) will flash.
Inserting/removing a cassette
1
Slide the [OPEN/EJECT] lever and open the 
cassette cover.
≥When the cover is fully opened, the cassette 
holder will come out.
2
After the cassette holder is opened, insert/
remove the cassette.
≥When inserting a cassette, orient it as shown 
in the figure, and then securely insert it as far 
as it goes.
≥When removing, pull it straight out.
3
Push the [PUSH] mark 
in order to close 
the cassette holder.
4
Only after the cassette holder is completely 
housed, close the cassette cover by 
pressing the mark 
2.
≥After using, make sure to rewind the cassette 
completely, remove it, and put it in a case. Store 
the case in an upright position. (
-51-
≥When condensation is formed on the lens or the 
main unit of the movie camera, even if no 
condensation alarm is indicated, condensation 
may have formed on the heads or the cassette 
tape. Do not open the cassette cover. (
-49-
ª
When the cassette holder does not 
come out
≥Close the cassette cover completely, and then 
open it again completely.
≥Check if the battery has run down.
≥Check if the cassette compartment cover is in 
contact with grip belt as shown below. If so, be 
sure the grip belt stays clear of the cover when 
opening.
ª
When the cassette holder cannot be 
housed
≥Set the [OFF/ON] switch to [OFF], then to [ON] 
again.
≥Check if the battery has run down.
ª
Inserting/removing the cassette
≥When the cassette holder is in action, do not 
touch anything except the [PUSH] mark.
≥When inserting a previously recorded cassette, 
use the blank search function to find the position 
where you want to continue recording. If you 
overwrite-record on a previously recorded 
cassette, be sure to find the position where you 
continue recording.
≥Close the cassette cover tightly.
≥When closing the cassette cover, do not get 
anything, such as a cable, caught in the cover.
ª
Accidental erasure prevention
If the accidental erasure prevention slider 
1 of a 
cassette is opened (slide in the direction of the 
[SAVE] arrow), the cassette cannot be recorded. 
When recording, close the accidental erasure 
prevention slider of the cassette (slide in the 
direction of the [REC] arrow).
OPEN/
EJECT
PUSH
1
2
R E C
SAVE
1
GS35_25GN.book  9 ページ  2005年1月31日 月曜日 午後3時25分