Panasonic VQT0C55 Benutzerhandbuch
E-28
PREPARATION
– Selecting the NTSC/PAL signal system –
This unit supports both the NTSC and PAL signal system.
Before inputting analogue signals (composite or YC separate video signals), please select the
signal system.
Before inputting analogue signals (composite or YC separate video signals), please select the
signal system.
REW
PLAY
STOP
REC INH.
PAL
AUDIO
NTSC
DVCAM
POWER
REC
A.DUB
CH
1 / 3
2 / 4
LINE
DV
S-VIDEO
OFF
9PIN
WIRELESS
INPUT
REMOTE
MIC
AG-DV2500
NTSC
indicator
indicator
POWER
button
button
PAL
indicator
indicator
VIDEO
/4
LINE
S -VIDEO
N
I
O
U
T
U
T
9PIN REMOTE
AUX
NTSC
PAL
DC
12V
OCK HAZARD - DO NOT OPEN.
CHOC ELECTRIQUE - NE PAS OUVRIR.
NTSC/PAL switch
Steps
1.
Set the unit to the POWER OFF mode.
2.
Please select the signal system with the NTSC/PAL switch on the rear panel.
3.
Press the POWER button to engage the POWER ON mode. Either the NTSC or PAL
indicator on the front will then light up, according to the NTSC/PAL switch setting.
indicator on the front will then light up, according to the NTSC/PAL switch setting.
Memo
• In the playback mode, the signal system of the tape is automatically identified, regardless of the
NTSC/PAL switch setting.
• During DV signal input, the signal system of the input signal is automatically identified, regardless
of the NTSC/PAL switch setting.
• This unit is equipped with a function to automatically detect the signal system of the cassette being
played back or the signal being received at the DV input connector. However, this function may not
operate correctly in some instances.
To ensure the correct system selection, it is recommended that you match the rear panel’s NTSC/
PAL switch to the signal system of the input signal or playback tape.
operate correctly in some instances.
To ensure the correct system selection, it is recommended that you match the rear panel’s NTSC/
PAL switch to the signal system of the input signal or playback tape.
• When the unit enters the STOP mode, the NTSC/PAL switch setting will be engaged.
• If a tape recorded in both NTSC & PAL signal systems is played, the video, audio or time code may
• If a tape recorded in both NTSC & PAL signal systems is played, the video, audio or time code may
be distorted at the position where the signal system is switched.
• When the signal system of the tape and the NTSC/PAL setting differ, video and sound output will be
upset for about 5 seconds after playback starts or stops.
• NTSC/PAL signal system conversion is not possible.