Sterling 882.000254.00 Benutzerhandbuch

7/50D Plus or 7/50D Controller 

Chapter 3:  Installation 

19 

10. Drive the two screws at the center points about halfway down; first on the latch side, 

then the hinge side. 

11. Continue to tighten the screws a little at a time until fully tightened; no more than 15 

inch-pounds (5.6 N

•

m) of torque. 

Once installed on the grey data cables, these connectors permit you to measure voltage in the 
system so you can analyze how it is working. The system cannot work properly unless these 
inside-mounted connectors have the blank (non-conductor) caps installed. 

1.  Lay the cable in the hinged base, noting the correct keyed profile; flat edge toward 

the hinge, keyed edge toward the latch. Make sure that the cable is properly seated 
inside. 

2.  Making sure that the cable is completely straight, carefully close the hinged 

assembly, and apply firm, even pressure until the first latch locks into place. 

The latch has two catches; the first loosely holds the connector on the cable, the 
second requires more pressure to close the connector tightly. The cable must be in the 
correct position for the connector to close properly. 

3.  Drive the two screws at the center points about halfway down; first on the latch side, 

then the hinge side. 

4.  Continue to tighten the screws a little at a time until fully tightened; no more than 15 

inch-pounds (5.6 N

•

m) of torque. 

The system should now be properly terminated. You can now continue to install components 
on the system.