Sterling 882.000254.00 Benutzerhandbuch
7/50D Plus or 7/50D Controller
Chapter 4: Operation
59
Logging On and Logging Off
Your controller may be set up to require a password for any operation (other than reviewing
station and pump status, silencing alarms, reviewing the alarm log, and looking at help
screens). If so, a keypad appears when you touch a button for a screen that requires a
password:
Your controller may be set up to require a password for any operation (other than reviewing
station and pump status, silencing alarms, reviewing the alarm log, and looking at help
screens). If so, a keypad appears when you touch a button for a screen that requires a
password:
• Enter the four-digit password (including any leading zeros). For
example, if the password is 1, enter 0001.
Each digit appears as an “X” as you touch it. When you touch the fourth digit, the
controller carries out your request. For example, it enables or disables the requested
pump or station, or it goes to the Station n Operator screen. If you did not enter the
correct password, the controller erases the entry. You can then try again. To give up,
touch Return.
controller carries out your request. For example, it enables or disables the requested
pump or station, or it goes to the Station n Operator screen. If you did not enter the
correct password, the controller erases the entry. You can then try again. To give up,
touch Return.
Note: If you have lost the password(s), contact the manufacturer for
assistance.
Once you have logged on, the password remains active until you log off or the password
expires. (Setup personnel at your facility control the number of minutes before the password
expires.) While the password is active, you can continue to carry out password-protected
tasks without reentering the password. If the timer expires, the controller goes to the Station
Summary screen and you must reenter the password to continue working.
expires. (Setup personnel at your facility control the number of minutes before the password
expires.) While the password is active, you can continue to carry out password-protected
tasks without reentering the password. If the timer expires, the controller goes to the Station
Summary screen and you must reenter the password to continue working.
When you have finished any tasks that require the password, you should log off. (If you
forget to do this, the controller will log you off when the password expires.) To log off:
forget to do this, the controller will log you off when the password expires.) To log off:
1. Go to a Station Operator screen.
To reach this screen, go to the Station Summary if needed by touching Stations at
any screen. Then touch and hold the icon for any station until its Station Operator
screen appears.
any screen. Then touch and hold the icon for any station until its Station Operator
screen appears.
2. Touch Log Off Operator near the lower right of the screen.
The Station Summary screen appears.