Sterling 882.000254.00 Benutzerhandbuch
7/50D Plus or 7/50D Controller
Chapter 1: Safety
7
1-2 Warnings and Precautions
Our equipment is designed to provide safe and reliable operation when installed and operated
within design specifications, following national and local safety codes. This may include, but
is not limited to OSHA, NEC, CSA, SPI, and any other local, national and international
regulations.
within design specifications, following national and local safety codes. This may include, but
is not limited to OSHA, NEC, CSA, SPI, and any other local, national and international
regulations.
To avoid possible personal injury or equipment damage when installing, operating, or
maintaining this equipment, use good judgment and follow these safe practices:
maintaining this equipment, use good judgment and follow these safe practices:
;
Read and follow these operation and installation instructions when installing,
operating, and maintaining this equipment. If these instructions become
damaged or unreadable, additional copies are available from the manufacturer.
damaged or unreadable, additional copies are available from the manufacturer.
;
Follow all SAFETY CODES.
;
Wear SAFETY GLASSES and WORK GLOVES.
;
Work only with approved tools and devices.
;
Disconnect and/or lock out power before servicing or maintaining the equipment.
;
Use care when LOADING, UNLOADING, RIGGING, or MOVING this
equipment.
;
Operate this equipment within design specifications.
;
OPEN, TAG, and LOCK ALL DISCONNECTS before working on equipment.
You should remove the fuses and carry them with you.
;
Make sure the equipment and components are properly GROUNDED before you
switch on power.
;
Use extreme caution when working with your conveying system. HIGH VACUUM
can be dangerous. Keep body parts, tools, clothing, and debris away from vacuum
inlets.
inlets.
;
When welding or brazing in or around this equipment, make sure VENTILATION is
ADEQUATE. PROTECT adjacent materials from flame or sparks by shielding with
sheet metal. An approved FIRE EXTINGUISHER should be close at hand and
ready for use if needed.
sheet metal. An approved FIRE EXTINGUISHER should be close at hand and
ready for use if needed.
;
Do not restore power until you remove all tools, test equipment, etc., and the
equipment and related components are fully reassembled.
;
Only PROPERLY TRAINED personnel familiar with the information in this
manual should work on this equipment.
We have long recognized the importance of safety and have designed and manufactured our
equipment with operator safety as a prime consideration. We expect you, as a user, to abide
by the foregoing recommendations in order to make operator safety a reality.
equipment with operator safety as a prime consideration. We expect you, as a user, to abide
by the foregoing recommendations in order to make operator safety a reality.