VTech CS6429 Benutzerhandbuch

3

The telephone comes ready for tabletop use. Follow the steps below to mount your 

telephone on a wall. 

Route the telephone line cord 

through the hole on the wall mount 

bracket and plug it into the telephone 

wall jack. Route the power cord out 

of the telephone base and plug it into 

an electrical outlet not controlled by 

a wall switch.

3.

Align the holes on the bracket with 

the standard wall plate and slide the 

bracket down until it locks securely. 

Bundle the telephone line cord  

and power adapter cord neatly  

with twist ties.

4.

Position the telephone base against 

the wall mount bracket as shown. 

Insert the extended tabs marked 

B 

on the wall mount bracket into the 

slots marked 

B on the back of the 

telephone base. Push the telephone 

base down until it clicks securely.

2.

Plug one end of the telephone line 

cord into the 

TEL LINE jack at the 

bottom of the telephone base and 

the base power adapter into the 

POWER jack.

.

Delete the playing 

message.
Press twice to delete 

all previously reviewed 

messages when the 

phone is not in use.

Shows the number of messages and other 

answering system information.

IN USE light

Flashes when there is an 

incoming call, or another 

telephone sharing the same 

line is in use.
On when the handset is in 

use, or the answering system 

is answering a call.

Press once and then release 

to page all system handsets.

Skip to the next message.

Play or stop playing messages.

Turn the answering system 

on or off.

Press to repeat a message or press 

twice to play the previous message.

/VOL  and  /VOL

Adjust the volume during 

message playback.
Adjust the telephone 

base ringer volume when 

the phone is not in use.

Once you have installed the battery, the screen indicates the battery status (see 

the table below).

For best performance, keep the handset in the telephone base or charger 

when not in use.
The battery is fully charged after 0 hours of continuous charging.
If you place the handset in the telephone base or the charger without 

plugging in the battery, the screen displays 

NO BATTERY.

•

•
•

Battery indicators

Battery status

Action

The screen is blank, 

or displays 

CHARGER and   flashes.

Battery has no or 

very little charge. The 

handset cannot be used.

Charge without interruption 

(about 30 minutes).

The screen displays  

LOW BATTERY and   

flashes.

Battery has enough 

charge to be used for a 

short time.

Charge without interruption 

(about 30 minutes).

The screen displays 

HANDSET X.

Battery is charged.

To keep the battery charged, 

place it in the telephone 

base or charger when not 

in use.