JVC CA-MD9R Benutzerhandbuch

❏ Press the 

¤ or ‹ button (or the £ button on the Remote Control).

The power comes on and “TAPE” appears on the display. When a tape is already in the cassette
holder, the tape is played in the direction of the button pressed. If there is no tape in the cassette
holder, the CA-MD9R automatically turns on and “NO TAPE” appears on the display.

If the power is already on, you can use this basic procedure:

0 button.

When the cassette holder opens, put a cassette in, with the exposed part of the tape down,
toward the base of the CA-MD9R.
❏ If the cassette holder does not open, turn off the unit, then back on and press down the 

0

button again.

¤ or ‹ button (or the £ button on the Remote Control).

The tape is played in the direction of the button pressed.
❏ The Cassette Deck automatically stops when one side of a tape has finished playing (except

if the deck is in auto reverse mode: see the next page).

Playing the front side

Playing the reverse side

❏ To change the tape direction using the Remote Control, press the TAPE DIRECTION button.

Each time you press the button, the tape direction alternates.

To stop playing, press the 

7 button.

To remove the tape, press down the 

0 button after stopping the play.

❏ While the tape is stopped, press the 

1 button and the tape will wind rapidly to the left side of

the cassette without playing.

❏ While the tape is stopped, press the 

¡ button and the tape will wind rapidly to the right side of

the cassette without playing.

EN.51-72.CA-MD9R[B]/F

98.2.13, 0:19 PM

52