Toshiba 40RV52RZ Benutzerhandbuch
Chapter 5: Setting up your TV
30
Programming channels into the
TV’s channel memory
When you press
or
on the remote control
or TV control panel, your TV will stop only on the
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into the
TV’s channel memory.
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into the
TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
• You must configure the ANT/CABLE input
source before programming channels (
page 29).
page 29).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV’s memory.
programmed into the TV’s memory.
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
Channel Number buttons on the remote
control.
• Programming channels when the ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless
your Cable TV service lineup changes
significantly.
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless
your Cable TV service lineup changes
significantly.
To program channels automatically:
1無
Configure the antenna input source, if you have
not already done so ( page 29).
not already done so ( page 29).
2無
Press
and open the
Setup menu.
3無
Highlight
Installation and press
.
4無
(A new set of
Installation menu icons will
appear, as shown below.) Open the
Terrestrial
menu, highlight
Channel Program to bring up
the
Start, and press
again to begin channel
programming.
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message “Scanning
channels, please wait” appears (as shown
above).
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message “Scanning
channels, please wait” appears (as shown
above).
5無
To cancel channel programming, press
on
the remote control (or highlight
Cancel in the on-
screen display and press
).
When channel programming is finished, press
or
to view the programmed channels.
Manually adding and deleting
channels in the channel memory
After automatically programming channels into the
channel memory, you can manually add or delete
individual channels.
channel memory, you can manually add or delete
individual channels.
To add or delete channels in the channel
memory:
memory:
1無
From the
Setup menu, highlight Installation and
press
. A new set of
Installation menu icons
will appear.
(continued)