Toshiba 29L1350U Benutzerhandbuch
![Toshiba](https://files.manualsbrain.com/attachments/acaaaa9cc6b763ccfc72ced2ae95d9c94b8b8632/common/fit/150/50/8adbcbcd45c75dc53932fc9caf6f2740daed52d836b76efbd0162ac2599f/brand_logo.png)
53
Setting up your TV
Auto Tuning
v
You must set up the ANT/CABLE input source before
programming channels. See
v
The automatic channel programming process will erase
channels that were previously programmed into the TV’s
memory.
v
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
v
Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than when the
antenna input is configured for Antenna. This is normal;
however, once channel programming is finished, you should not
have to repeat the programming process again unless your Cable
TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have not already
done so, see
2
Press the MENU button and open the Installation menu.
3
Highlight Channel Tuning, and then press the ENTER button.
Turning
(Sample Image) Setup menu - Installation selection
4
4
Highlight Auto Tuning, and then press the ENTER button to
open the Channel Program menu to begin channel
programming.
Cable
Scanning channels, please wait...
Number of Channels Found - 7
Scanning Analog Channels
Scanning Analog Channels
6%
Channel - 9
Cancel
!
(Sample Image) Installation menu - Channel selection