Venturer PLV76198E Benutzerhandbuch

GB - 2

• DANGER  OF  EXPLOSION  IF  BATTERY  IS

INCORRECTLY  REPLACED.  REPLACE  ONLY

WITH THE SAME OR EQUIVALENT TYPE.

• TO  PREVENT  ELECTRIC  SHOCK,  MATCH

WIDE  BLADE  OF  PLUG  TO  WIDE  SLOT  OF  WALL

OUTLET, THEN FULLY INSERT.

•  USE  OF  CONTROLS  OR  ADJUSTMENTS  OR

PERFORMANCE  OF  PROCEDURES  OTHER  THAN

THOSE  SPECIFIED  MAY  RESULT  IN  HAZARDOUS

RADIATION EXPOSURE.

•  To reduce the risk of fire or shock hazard, do not expose

this unit to rain or moisture.

•  Main plug is used as disconnect device and it should

remain readily operable during intended use.

•  The unit shall not be exposed to dripping or splashing

and that no objects filled with liquids, such as vases,

shall be placed on unit.

•  In  order  to  disconnected  the  unit  from  the  mains

completely, the AC power cord should be disconnected

from the mains socket outlet completely.

•  Battery shall not be exposed to excessive heat such as

sunshine, fire or the like.

•  Do not use this unit in places which are extremely hot,

cold, dusty or humid.

•  Do  not  restrict  the  air  flow  of  this  unit  by  placing  it

somewhere  with  poor  air  flow,  by  covering  it  with  a

cloth, by placing it on bedding or carpeting.

•  When connecting or disconnecting the AC power cord,

grip  the  plug  and  not  the  cord  itself.  Pulling  the  cord

may damage it and create a hazard.

•  When you are not going to use the unit for a long period

of time, disconnect the AC power cord.

•  When left in a heated room where it is warm and damp,

water  droplets  or  condensation  may  form  inside  the

equipment. When there is condensation inside the unit,

the unit may not function normally. Let the unit stand for

1-2 hours before turning the power on or gradually heat

the room and let the unit dry before use.

The rating plate is located on the rear of the unit.

This  device  complies  with  Part  15  of  the  FCC  Rules.

Operation is subject to the following two conditions: (1) This

device  may  not  cause  harmful  interference,  and  (2)  This

device  must  accept  any  interference  received,  including

interference that may cause undesired operation.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of  the  FCC  Rules.  These  limits  are  designed  to  provide

reasonable  protection  against  harmful  interference  in  a

residential installation. This unit generates, uses and can

radiate  radio  frequency  energy  and,  if  not  installed  and

used  in  accordance  with  the  instructions,  may  cause

harmful  interference  to  radio  communication.  However,

there is not guarantee that interference will not occur in

a  particular  installation.  If  this  unit  does  cause  harmful

interference  to  radio  or  television  reception,  which  can

be determined by turning the unit off and on, the user is

encouraged  to  try  to  correct  the  interference  by  one  or

more of the following measures:

-  Reorient or relocate the receiving antenna.

-  Increase the separation between the unit and receiver.

-  Connect the unit into an outlet on a circuit different from

that to which the receiver is connected.

-  Consult  the  dealer  or  an  experienced  radio/TV

technician for help.

-  Shielded cables must be used with this unit to ensure

compliance with the Class B FCC limit.

-  This  television  receiver  provides  display  of  television

closed  captioning  in  accordance  with  Section  15.119

of the FCC rules.

WARNING: Changes or modifications to this unit

not expressly approved by the party responsible

for  compliance  could  void  the  user  authority  to

operate the unit.

The lightning flash with an arrowhead symbol, 

within  the  equilateral  triangle,  is  intended  to 

alert  the  user  to  the  presence  of  uninsulated 

"dangerous  voltage"  within  the  product's 

enclosure that may be of sufficient magnitude 

to cause an electric shock.
The  exclamation  point  within  the  equilateral 

triangle  is  intended  to  alert  the  user  to 

the  presence  of  important  operating  and 

maintenance  (servicing)  instructions  in  this 

owner manual.

caution

The symbol for Class II

(Double Insulation)

PLV76198S23E10 IB ENG.indd   2

9/8/2009   9:57:24 AM