Philips MCD2010 Benutzerhandbuch
14
4
Press
PROG/CLOCK SET to confirm the
setup.
Note
•
The number key on the remote control is
deactivated in this mode.
Store radio stations
automatically
If no radio stations are stored, the unit can store
radio stations automatically.
1
Turn on the unit.
2
Press
FM.
»
[AUTO INSTALL -- PRESS PLAY --
STOP CANCEL] (press
to start
automatic installation, or press to
cancel) is displayed.
3
Press .
»
The unit automatically stores radio
stations with sufficient signal strength.
»
After all available radio stations are
stored, the first stored radio station is
broadcast automatically.
Find the correct video input
channel
1
1
Turn on your unit.
2
Press
DISC to select the disc source.
• Turn on the TV and switch to the
correct video-in channel.
Note
•
See the user manual of your TV for how to
switch between video-in channels.
4 Get started
Turn on
1
1
Press .
»
The unit switches to the last selected
source.
Note
•
If no source is played within 15 minutes, the
unit switches to standby mode.
•
If no operation is performed within 15 minutes
in standby mode, the unit switches to Eco-
power standby mode.
•
Press to switch the unit to the last source
when it was turned off.
Demonstrate the unit’s features
1
In the standby mode, press until
“DEMO ON” is displayed.
»
This system’s features are displayed
one by one.
• To turn off the demonstration, press
again.
Set the clock
The unit uses the 24-hour or 12-hour time
format.
1
In standby mode, press and hold PROG/
CLOCK SET for three seconds.
»
“CLOCK SET” scrolls on the display.
Then the time format [24H] or [12H]
is displayed.
2
Press / to select a time format. Press
PROG/CLOCK SET to store the setting.
»
The hour digits blink.
3
Press / to set the hour. Press PROG/
CLOCK SET to store the setting.
»
The minute digits blink.
EN
MCD2010_12_UM_Book1_V3.2.indb 14
8/10/2012 9:39:59 AM