RGB Spectrum DGy 201x Benutzerhandbuch

. . . . .

. . . . . . . . . 

The table below lists all DGy 201x input commands, their arguments and 
detailed descriptions.

INputAutoSync

<AUTO | LOCK | 
DEBUG>

AUTO engages the input autosync circuitry. LOCK 
turns the autosync circuitry off. If the source is 
slightly unstable this prevents the autosync circuitry 
from constantly re-acquiring the signal. DEBUG 
provides information on input status, and reports 
changes to measured parameters (serial port only).

Default: AUTO

INputFormat

(none)

INputFormat is a read only command that reports 
the type of signal selected for recording. 

INputLOAD

<1..160>

Loads the indicated entry from the Timing List to 
the RGB input channel.

This command only operates when an analog RGB 
signal is present and selected (with the 

 command). Otherwise an error 

message will be returned.

Refer to the 

 section for 

additional details.

INputMODulus

(none)

This command provides a way to optimize the input 
timing for the analog RGB input to exactly sample 
the center of each pixel. 

A reasonably busy image is required for alignment 
(for example a screen with fine vertical lines or a 
screen with lots of fine text). After issuing the 
command the following letters may be pressed to 
make changes.

i = increase modulus

m =decrease modulus

j = decrease phase

l= increase phase

J = move left 

L = move right

I = move up 

M = move down

: these are case sensitive.

With the image properly adjusted, quit the utility:

q = quit 

If the timing of the analog source is known, it should 
be entered with the 

 command, but the 

INputMODulus command may still be used to set 
the sampling phase interactively.