RGB Spectrum DGy 201x Benutzerhandbuch

. . . . .

. . . . . . . . . 

Use the following steps to change the DGy 201x IP address using the 
serial port:

Connect DGy 201x as outlined in the 

 section in 

Chapter 2 and set up the Hyperterminal as described in the 

 section on page 131 of this chapter.

In the Hyperterminal window, type:

IPADDR

... and press ENTER.

DGy 201x responds with the current IP address. Make a note of 
the address before proceeding with the next step. 

Type 

IPADDR

 followed by a space, and the new IP address (as 

provided to by the network administrator). 

S

Example: If the new IP address is 192.168.1.190, type:

IPADDR 192.168.1.190 

... and press ENTER.

DGy 201x responds with the following message:

The system must be restarted for your changes to 

take effect. Do you want to restart the system 

(y/n)?

~

Press y to restart DGy 201x and use the newly 
assigned IP address.

~

Press n to retain the current IP address, and discard the 
new address.

After the DGy 201x restarts, confirm the new setting by typing 
the command 

IPADDR

. If the DGy 201x has accepted the 

command, it responds with the new IP address just entered.

Once IP address has been set, connect the PC to the DGy 201x using 
Ethernet. In Chapter 2, refer to the 

 section for 

instructions.