Pelco C1669M (4/05) Benutzerhandbuch
C1669M (4/05)
3
DX8000 Settings Export/Import Procedure
This section describes how to upgrade the DX8000 Series DVR software from Version 1.0.00.1088 to Version 1.1.00.1121.
The DX8000 Settings export/import procedure describes how to do the following:
•
Export your current DX8000 configuration settings
•
Use the DX8000 Recovery CD to upgrade from Version 1.0.00.1088 to Version 1.1.00.1121
•
Import your current DX8000 configuration settings and configure the new version of DX8000 software
This procedure ensures that you will have a smooth transition to the next version of DX8000 software.
There are two phases to perform the DX8000 settings export/import procedure: export and import. The steps to perform the export and import
phases are summarized as follows:
phases are summarized as follows:
•
Export settings phase:
–
–
Step 1: Recording DX8000 Network Settings
–
Step 2: Exporting DVR Settings
–
Step 3: Recording IP Security Settings
–
Step 4: Running the DX8000 Recovery Procedure
•
Import settings phase:
–
–
Step 5: Entering Networking Settings
–
Step 6: Importing the DX8000 DVR Settings
–
Step 7: Configuring IP Security Settings
EXPORT PHASE
Step 1: Recording DX8000 Network Settings
To document the DX8000 network settings:
1. Click the Setup icon.
2. Click the Network icon.
3. Do the following:
a.
Record the DX8000 IP address: ___________________________.
b.
Record the subnet mask: ________________________________.
c.
Record the default gateway address: ________________________.
d.
Indicate if Obtain an IP Address Automatically is: Checked_____ Unchecked_____.