RGB Spectrum 201 Benutzerhandbuch

. . . . .

When a recording is made the recording is stamped with a time 
code. The Playback tab provides the ability to go directly to a 
time code position within the currently selected clip - providing 
random access to any point within a clip. This is equivalent to 
the RealTimeSeek command. You may seek to a time code 
when DGy 201 is in either Play, Pause or Stop mode.

Use the following procedure to go to a specific time code:

~

From the WCP Player Screen (Figure 3-3) click on the 
Options button

~

On the Options page select the Playback tab

~

Select the date of the clip by entering directly into the 
Date field or using the spin controls.

~

Select the time that you are seeking to by entering 
directly into the Time field.

~

Click on the Go button

The DGy 201 will cue to the specified time code if the 
time code is within the scope of the current clip.

~

Click on Play to commence playback from the specified 
point.

The “Enable playback loop” check box enables the playback 
loop feature. This causes the DGy 201 to repeatedly play the 
current clip.

The Advanced Playback Console supports the following 
playback functions:

•

Previous Frame

•

Next Frame

•

Slow Reverse Play

•

Slow Forward Play

•

A-B Loop

By default the Advanced Playback controls are enabled, but if 
they are not visible click in the Enable Advanced Playback 
Console check box on the Playback Tab page. The drop down 
control panel will be displayed below the basic player control 
panel as shown in Figure 3-3.  The control screen is shown 
separately in Figure 3-11 below.