RGB Spectrum 201 Benutzerhandbuch

. . . . .

~

Use the Mode drop down menu to select between the 
Playback and Free-run modes. In the Free-run mode 
the output timing parameters are set by the user. In the 
Playback mode the output timing parameters are 
automatically loaded to match the format of the clip that 
is being played.

~

Use the Test Pattern drop down menu to select a test 
pattern to display on the output port. The test pattern 
provides a simple way to confirm that the output is 
correctly connected to a display device.

~

Use the Gamma spin box to change the gamma of the 
playback image for both analog and DVI outputs. 

Note: The gamma of the input image recorded to disk is 
preserved. The Gamma control does not apply to the 
input image.

~

Use the Timing List section of the Output page to set 
the output format. To select a new Output format, select 
the required format from the drop down Timing list and 
click on the Load button. The timing parameters 
associated with the format are listed in the Video 
Output Timing section of the Output page. These 
parameters may be changed by clicking on the Edit 
button and making the required changes to the 
parameters in the Video Output Timing fields. This 
new setting may then be saved to the Timing List by 
selecting an unused entry in the list and clicking the 
Save button. Unwanted entries to the Timing List can be 
deleted by selecting the timing entry that you wish to 
delete in the drop down Timing List box, and clicking on 
the Delete button.

. . . . . . . . . 

The figure below illustrates the System Tab.

The System Tab is used to view and set communications parameters in 
addition to setting the DGy 201’s internal clock.