Panasonic CY-TUN153U Benutzerhandbuch

4

5

 This unit is designed for use exclusively in 

 Do not operate the unit for a prolonged period with 

  Operating the audio system for a long period of time 

with the engine turned off will drain the battery. 

 Do not expose the unit to direct sunlight or excessive 

  Otherwise these will raise the interior temperature 

of the unit, and it may lead to smoke, fi re, or other 
damage to the unit. 

 Do not use the product where it will be exposed to 

  Exposure of the unit to water, moisture, or dust may 

lead to smoke, fi re, or other damage to the unit. Make 
especially sure that the unit does not get wet in car 
washes or on rainy days.

 If your car is equipped with air bag and/or anti-theft 

 FAILURE TO FOLLOW THE PROCEDURE MAY RESULT 

 Refer wiring and installation to qualifi ed service 

  Installation of this unit requires special skills and 

experience. For maximum safety, have it installed by 
your dealer. Panasonic is not liable for any problems 
resulting from your own installation of the unit. 

 Follow the instructions to install and wire the product.  
  Not following the instructions to properly install and 

wire the product could cause an accident or fi re. 

 Take care not to damage the leads.  
  When wiring, take care not to damage the leads. 

Prevent them from getting caught in the vehicle 
chassis, screws, and moving parts such as seat rails. 
Do not scratch, pull, bend or twist the leads. Do not run 
them near heat sources or place heavy objects on them. 
If leads must be run over sharp metal edges, protect 
the leads by winding them with vinyl tape or similar 
protection. 

 Use the designated parts and tools for installation.  
  Use the supplied or designated parts and appropriate 

tools to install the product. The use of parts other than 
those supplied or designated may result in internal 
damage to the unit. Faulty installation may lead to an 
accident, a malfunction or fi re.  

 Do not install the product where it is exposed to 

  Avoid slanted or strongly curved surfaces for 

installation. If the installation is not stable, the unit may 
fall down while driving and this can lead to an accident 
or injury. 

 Ware gloves for safety. Make sure that wiring is 

 To prevent damage to the unit, do not connect the 

power connector until the whole wiring is completed.   

 Never mount the unit in any of the following locations 

to avoid damage due to overheating;

  • Near the heater port. 
  •  Places like the dashboard or rear deck, where it may 

be exposed to direct sunlight. 

 Do not mount the unit near the door, where it could be 

exposed to rain. 

 You run the risk of interfering with the mounting or 

causing damage by drilling into the gas tank, a wiring 
harness, or other component.

 Note that if your car has a driving computer or a 

navigation computer, disconnecting the cable from the 
battery may clear the memory. 

 Fit a vinyl cap over unused connection terminals, to 

prevent contact with metal parts etc.

Proper Use of the Batteries 
 Use only specifi ed battery (CR2025).
 Match the polarity of the battery with the () and () 

marks in the battery case. 

 Replace a dead battery as soon as possible. 
 Remove the battery from the remote control unit when 

not using it for an extended period of time. 

 Insulate the battery (by placing them in a plastic bag 

or covering them with vinyl tape) before disposal or 
storage. 

 Do not disassemble, recharge, heat or short the battery. 

Do not throw a battery into a fi re or water. 

 Follow local regulations when disposing of a battery. 
 Improper use of a battery may cause overheating, an 

explosion or ignition, resulting in injury or a fi re. 

In case of battery leakage
 Thoroughly wipe the battery liquid off the battery case 

and insert new battery. 

 If any part of your body or clothing comes into contact 

with battery liquid, wash it with plenty of water. 

 If battery liquid comes into contact with your eyes, 

wash them with plenty of water and get immediate 
medical attention. 

 Attach the TV antenna so that it does not protrude. 

If the antenna element extends beyond the front and 
rear of the vehicle or car, it could hit eyes or heads of 
pedestrians and potentially cause an accident or an 
injury.

 Place the TV antenna so that it does not impede driving 

or visibility. If the antenna is in a position that impairs 
forward or backward visibility, it could interfere with 
driving and cause an accident.

 Do not disassemble or modify the TV antenna. Such 

modifi cation could start smoke or fi re. 

 Fasten the TV antenna securely, so that it cannot drop 

off. If the screws are loose or the bond at the mounting 
is weak, the antenna could fall off, potentially causing 
damage to the car bodywork, accident or injury. Inspect 
it occasionally. 

 Be sure to install the TV antenna on the inner side of 

the rear window.

 Be sure to connect the power lead of the TV antenna to 

ACC power DC 12 V.

 Keep the antenna away from the external amplifi er and 

the rear speaker cord as much as possible.

 Be sure to connect the grounding plate into the TV 

antenna body. Otherwise, desensitization will occur.  

 Avoid contacting the back of the TV antenna body on 

the adhesive surface.  

 Do not re-adhere the back of the TV antenna body to 

avoid weakening adherability. 

 Avoid adhering the TV antenna on the heating wire as 

much as possible. 

3

4