Mitel 5505 Benutzerhandbuch

Pairing the 5505 Cordless Handsets

The 5505 Guest IP Phone supports up to four 5505 Cordless handsets. One handset comes 
from the factory pre-paired with the base station. You can pair the remaining handsets by 
following the instructions below. 

It is recommended that the handsets be paired after the 5505 Guest Phone has been 
registerered; however, if you wish to pair handsets on an unregistered 5505 Guest Phone, 
press the End Call key to end registration.

Note: Only one handset can be paired at a time. The pairing must be completed before pairing 

the next handset

1. On the 5505 Base Station, press down both the Volume Up/Down indicators on the 

Volume key.  

2. Then release the Volume Down (—) portion. 
3. While the Volume Up key is pressed, type 7247 (PAIR) on the base station to start 

the pairing process.

 The Mute, Message and Line in Use keys start flashing to indicate an empty device slot is 
available for pairing.

4. On the handset, press MENU -> Settings -> OK -> Handset -> OK -> Register HS?
5. Enter the Wireless PIN and press OK.  

Registering ... appears on the handset.

Note: In ESM, refer to User and Device Configuration -> Access Authentication -> Wireless 

PIN.

After successful pairing, Handset Registered is temporarily displayed on the handset, and 
the indicators stop flashing on the base station. See “Maintenance and Troubleshooting” 
on page 39 if the handset didn’t register successfuly.

6. To verify successful registration, press the handset locator button (in the handset 

pocket on the base station). This will cause all paired handsets to start ringing. 

7. Continue to pair the next handset, if necessary.
8. At any time, press the End Call key 

 on the base station to exit from pairing mode.