Aastra Telecom 41-001343-02 Benutzerhandbuch
Firmware Installation Information
1-49
41-001343-02 REV04 – 05.2014
Firmware Installation Information
Description
The firmware setup and installation for the IP phone can be done using any of the following:
•
Phone User Interface via the keypad (Phone UI)
•
Aastra Web-based user interface (Aastra Web UI)
When the IP phone is initialized for the first time, DHCP is enabled by default. Depending on the type of configuration
server setup you may have, the IP phone may download a firmware version automatically, or you may need to download
it manually.
server setup you may have, the IP phone may download a firmware version automatically, or you may need to download
it manually.
Installation Considerations
The following considerations must be made before connecting the IP phone to the network:
•
If you are planning on using dynamic IP addresses, make sure a DHCP server is enabled and running on your network.
•
on
for manually setting up an IP address.
To install the IP phone hardware and cabling, refer to the <Model-Specific> SIP IP Phone Installation Guide.
Installation Requirements
The following are general requirements for setting up and using your SIP IP phone:
•
SIP-based IP PBX system or network installed and running with a SIP account created for the IP phone
•
Access to a Trivial File Transfer Protocol (TFTP), File Transfer Protocol (FTP), Hypertext Transfer Protocol (HTTP) server,
or Hyper Text Transfer Protocol over Secure Sockets Layer (SSL) (HTTPS)
or Hyper Text Transfer Protocol over Secure Sockets Layer (SSL) (HTTPS)
•
Ethernet/Fast Ethernet LAN (10/100 Mb) (Gigabit Ethernet LAN [1000 Mbps] recommended for Gigabit Ethernet com-
pliant phones)
pliant phones)
•
Category 5/5e straight through cabling (Category 6 straight-through cabling recommended for Gigabit Ethernet com-
pliant phones)
pliant phones)
•
Power source
–
For Ethernet networks that supply inline power to the phone (IEEE 802.3af ) use an Ethernet cable to connect from
the phone directly to the network for power (no 48V AC power adapter required if using Power-over-Ethernet
[PoE])
the phone directly to the network for power (no 48V AC power adapter required if using Power-over-Ethernet
[PoE])
–
For Ethernet networks that DO NOT supply power to the phone:
Use the respective power adaptor to connect from the DC power port on the phone to a power source
or
Use a PoE power injector or a PoE switch
Configuration Server Requirement
A basic requirement for setting up the IP phone is to have a configuration server. The configuration server allows you to:
•
Store the firmware images that you need to download to your IP phone
•
Stores configuration files for the IP phone
Reference
To set the protocol for your configuration server, see
.
To update the firmware on your phone, see