Panasonic KX-TG7123E Benutzerhandbuch
Useful Information
35
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
The handset/base unit stops
working while being used.
working while being used.
L
Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
handset. Connect the AC adaptor, turn on the
handset and try again.
Pressing {R} does not
display/dial the last number dialled.
display/dial the last number dialled.
L
The redialled number was more than 24 digits long.
Redial the number manually.
Redial the number manually.
The handset beeps intermittently
and/or 7 flashes.
and/or 7 flashes.
L
Fully charge the batteries (page 10).
I fully charged the batteries, but
7
7
still flashes.
L
Clean the charge contacts and charge again (page
10).
10).
L
It is time to replace the batteries (page 9).
Caller information is not displayed. L You must subscribe to Caller ID service.
L
Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
While viewing caller information,
the display returns to standby
mode.
the display returns to standby
mode.
L
Do not pause for over 1 minute while searching.
I cannot register a handset to the
base unit.
base unit.
L
The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 29).
registered to the base unit. Cancel unused handset
registrations from the base unit (page 29).
L
You entered the wrong PIN number. If you forget
your PIN, see “I cannot remember the PIN.” (page
35).
your PIN, see “I cannot remember the PIN.” (page
35).
L
Place the handset and the base unit away from
other electrical appliances.
other electrical appliances.
I cannot remember the PIN.
L
Change the PIN using the following method.
1
{j
/OK}
2
Press {^} or {V} to select “Base Unit
Setup”. i {>}
Setup”. i {>}
3
“Other Options” i {>}
4
“Base Unit PIN” i {>}
5
Press {*}{7}{0}{0}{0}.
6
Enter the new 4-digit base unit PIN. i {>}
i
i
{ih}
Problem
Cause & solution
TG7100-7120E(e).book Page 35 Tuesday, July 4, 2006 3:29 PM