Toshiba 50HMX96 Benutzerhandbuch
53
HMX96 (E/F) Web 213:276
Chapter 5: Using the TV’s features
•
Clock Phase:
Helps to reduce noise and sharpen the picture.
The adjustment range is within ±2 from center.*
Helps to reduce noise and sharpen the picture.
The adjustment range is within ±2 from center.*
•
Sampling Clock:
Helps to redure noise and minimize periodic vertical stripes
on the screen.
The adjustment range is within ±15 from center.*
Helps to redure noise and minimize periodic vertical stripes
on the screen.
The adjustment range is within ±15 from center.*
*
The range of adjustment may vary slightly.
Displaying TV setting information
on-screen using RECALL
on-screen using RECALL
To display TV setting information on-screen:
Press
E on the remote control.
The following information will display on-screen
(if applicable):
(if applicable):
•
Current input (ANT 1, ANT 2, VIDEO 1, etc.)
•
If ANT 1 or ANT 2 is the current input, either “CABLE”
(for cable TV) or “TV” (for over-the-air broadcasts).
(for cable TV) or “TV” (for over-the-air broadcasts).
•
Channel number (if in ANT 1 or ANT 2 mode)
•
Digital signal strength indicator (bar graph in lower right
corner of screen; for ATSC signal only)
corner of screen; for ATSC signal only)
Note: The signal strength indicator will react to fading and
increasing signals.
increasing signals.
•
Remaining time on sleep timer (if set)
•
Stereo or SAP audio status
•
V-Chip rating status
•
Picture size
•
Video resolution
•
Lamp mode (appears only if the TV is in High Bright mode)
To close the RECALL screen:
Press
E again.
Understanding the auto power off
feature
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
Understanding the last mode
memory feature
memory feature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Note: You should unplug the TV’s power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored.
that you will be away from the TV for an extended period of time
after the power is restored.
STEREO
CABLE
81-1
ANT 1
Lamp High Bright
NC-17
Sleep Timer: 18 min.
Natural
480i
Sample RECALL screen
HMX96_EN.book Page 53 Friday, April 28, 2006 12:03 PM