Davis Instruments Vantage Pro2 Benutzerhandbuch

Console Location

6

2. Ensure that the ISS cable is not twisted through the access port.

Note: 

The ISS must be assembled and connected to the console so that it is receiving 
power before the console connection can be tested.

Once the console and ISS are both powered up, cable connection should be 
tested and established.

Once the console is powered, it automatically enters Setup Mode. You can 
step through the Setup Mode options, or exit the Setup Mode to test the 
connection and sensor readings in Current Weather Mode. See “Setup 
Mode” on page 9 for Setup Mode options. See “Current Weather Mode” on 
page 20 for viewing and verifying current weather data coming from the 
cabled console.

To verify that the console is receiving data from the ISS through the con-
sole connection, see “Cabled ISS Assembly” in the Integrated Sensor Suite 
Installation Manual. 

You should place the console in a location where the keyboard is easily 
accessible and the display is easy to read. For more accurate readings, fol-
low these suggestions.

•

Avoid placing the console in direct sunlight. This may cause erroneous 
inside temperature and humidity readings and may damage to the unit.

•

Avoid placing the console near radiators or heating/air conditioning 
ducts.

•

If you are mounting the console on a wall, choose an interior wall. 
Avoid exterior walls that tend to heat up or cool down depending on the 
weather.

•

If you have a wireless console, be aware of possible interference from 
cordless phones or other devices. To prevent interference, maintain a 
distance of 10 feet between the Vantage Pro2 console and a cordless 
phone (handset and base). 

To ISS