Kathrein 300/HDP 170 Benutzerhandbuch

936.2412/B/0304/1

.2e/ZWT

1. Switch on the receiver with the mains switch. If the red LED is illuminated (ready for operation), press the stand-by 

button on the remote control in order to put the receiver into operation (green LED is illuminated).

2. The screen shows for about 10 seconds:

4. After initialisation, the last satellite position is 

approached, the following picture appears:

7. After this, the following insertion will appear 

and after another few seconds the desired TV 

programme is shown as full picture:

5. If the satellite signal is not found, the inserti-

on mentioned below will apear. Press the 

button in order to start the search mode (the 

satellite name may vary, depending on the pro-

gramme memory position, e.g. HOTBIRD).

6. If the satellite signal is found, at first only a small 

partial picture appears above at right.
Do not stop the search now, since the receiver 

signal reception!
(This procedure may last up to two minutes depen-

ding on the reception situation)

No signal!

Signal 

3. After that, the screen indicates for about 20 sec.:

Note:
The 

F-button of your remote control unit allows you at almost any time to start a satellite search (Exceptions: You have called up a 

menu or a different OSD is already shown). Furthermore, the search will not start if you already have a TV signal. After having pressed 

the 

F-button, the present satellite position is approached; if there is no signal, the OSD for point 5 will appear. Then continue the pro-

cedure as mentioned under point 5.