Polycom DOC2702A Benutzerhandbuch

Chapter 23-RMX Hardware Monitoring

Polycom, Inc.

The selected tests are initialized. In the Tests Monitoring pane there is an indication of 

the Connection Status of the Tests.

This process may take some time. Click Stop Running Test to end all the diagnostic tests. 

The MCU completes the current test running and then stops all remaining tests.

The Diagnostics Mode can be exited by pressing the yellow System Reset icon. The RMX 

then resets.

A hardware component’s test status can be viewed in the Diagnostics Test Monitoring 

section before, during and after tests have been initiated. Test results will only be displayed 

after tests are completed. The Diagnostic Tests Monitoring section is comprised of three 

tabs: MCU Monitor, Cards Monitor and Error Buffer, which are further described below.

The MCU Monitor tab lists the status of all the cards that can be tested in Diagnostic Mode. 

Described below are the columns:

Runs all tests listed in the TestActive column for the hardware 
component.