Mitsubishi Electronics FX3G-EEPROM-32L Benutzerhandbuch
69
FX
3S
Series Programmable Controllers
User's Manual - Hardware Edition
1
Introduc
tion
2
Features an
d
Par
t N
t N
am
es
3
Produc
t
Introducti
on
4
Sp
ec
ific
atio
ns
5
Ve
rsi
on and
Peri
pheral
pheral
De
vice
s
6
Sy
stem
Confi
gurati
on
7
In
st
alla
tio
n
8
Prep
ara
tion and
Pow
er Supply
Wi
ring
9
Input W
iri
ng
10
Hi
gh
-S
peed
Counters
8 Preparation for Wiring and Power Supply Wiring Procedures
8.2 Cable Connecting Procedures
8.2.3
Grounding terminal of the FX
3G
-485-BD-RJ
The grounding terminal of the FX
3G
-485-BD-RJ is a terminal blocks for Europe.
1. Applicable cables
2. Treatment of electric wire ends
• When using a stranded cable or solid cable as it is
- Twist the end of the stranded cable so that loose wires will not stick out.
- Do not solder-plate the end of the cable.
- Do not solder-plate the end of the cable.
3. Tightening torque
Set the tightening torque to 0.5 to 0.6 N•m.
Do not tighten terminal screws with a torque outside the above-mentioned range.
Failure to do so may cause equipment failures or malfunctions.
Caution
Do not tighten terminal screws with a torque outside the above-mentioned range.
Failure to do so may cause equipment failures or malfunctions.
Caution
When tightening a grounding terminal, use a screwdriver suitable for the terminal screw. The screwdriver
which does not suit the thread groove is used, tightening torque will not be able to be achieved. To achieve
the appropriate tightening torque shown in the above, use the following screwdriver or an appropriate
replacement.
which does not suit the thread groove is used, tightening torque will not be able to be achieved. To achieve
the appropriate tightening torque shown in the above, use the following screwdriver or an appropriate
replacement.
<Reference>
Electric wire size
AWG 20 to 16
Manufacturer
Model name
Phoenix Contact Co., Ltd
SZF 1-0.6
3.5
Approx. 6 mm
(0.24″)