Sterling 882.00722.00 Benutzerhandbuch

 

Chapter 7: Appendix 

55 of 60 

 

The Setup screen allows you to change the default User Password that the GH Hopper uses to 
lock out certain screens.  The password by default is “5413”.  To change the password, 
follow the steps listed below: 

1.  Set the Selected Operator to “USER” by touching the box located next to “Select 

Operator”. 

2.  Touch “New Password” and enter in a new password. 

3.  Touch “Verify Password” and enter in the same password. 

4.  A message telling you that the password has been changed will appear. 

Figure 75: Typical User Password Setup Screen 

 

If the Customer locks themselves out of a GH Hopper they can contact the manufacturer for a 
procedure that will let them back in.  This password is used in several places throughout the 
GH Hopper, but can be bypassed by entering in the Manufacturer’s Service Password. 

This screen allows the user to change the GH Hopper’s unit of measurement.  The entire GH 
Hopper can be configured in either Kgs. or Lbs., while the Target vs. Actual data can be 
configured for either regardless of the GH Hopper’s units. 

This screen shows the last 100 stored alarms.  The log can be viewed, printed and cleared. 

Figure 79: Typical Alarm Log Screen 

 

Clear Alarm 
Log 

Print Alarm 
Log 

Alarm Log 

Go back to 
Setup 
Directory 

Scroll Through 
Alarm Log 

1. Select “USER” 

4.  Back to Setup 

Directory 

2.  Enter New 
Password Here 

3.  Verify New 

Password to 

Finish