Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Channel Plus
  4. 9521BID COLOR
  5. Benutzerhandbuch

Channel Plus 9521BID COLOR Benutzerhandbuch

Download
Seite von 6
10
Installation: Step One
Locate the incoming CATV or antenna feed and existing splitter.
(Usually found on the side of the house, in the attic or near the electrical and phone service box)
Remove the lock screw located on the bottom of the channel 
injector and slide the cover off. Use the mounting holes as shown to
affix the channel injector to the wall next to the splitter.
Disconnect the incoming CATV or antenna feed from the existing
splitter and attach it to the channel injector as shown.
Now attach the supplied coax jumper back to the existing splitter
and tighten all connections with a 7/16” wrench.
3
© 1999
Use mounting
holes on the
bottom plate to
attach channel
injector to the
wall
Incoming CATV or
antenna coax
Out 
to TVs
© 1999
Incoming CATV or
antenna coax
Supplied coax
jumper goes back
to splitter
Out 
to TVs
After
Before
Mount the 
injector within
4” of the splitter
Mount the 
injector within
4” of the splitter
Specifications: typical @ 25°C ± 5° C  
9511 (B&W)    9511PAL(AUS)     9521 (Color)
HHR/BID                                   HHR/BID
lens viewing angle                                            78°
resolution: horizontal            525 lines            525 lines                525 lines
vertical                350 lines            350 lines                350 lines
standard lens cover:                                      smoked                              
minimum light level                2 lux                   2 lux                       8 lux
video input format                  EIA                    CCIR                      NTSC
input signal
1.0 V peak-to-peak @ 75
Ω
signal-to-noise ratio
>45 dB
white balance
automatic
electronic shutter speed
automatic: 1/60 to 1/50,000 second
tuning range UHF                14 to 64         21 to 62(28 to 67)         14 to 64  
CATV              65 to 125
A                                                                                  
65 to 125
A 
power supply                                        included with product
mains power                     105 to 125            210 to 250              105 to 125
output of power supply                              15VDC 600mA
general 
injector module                  camera module
width x height x depth       6.5” x 3.5” x 1.25”            2.75” x 4.5” x 3”
(16.3cm x 9cm x 3.2cm)    (6.9 cm x 11.4cm x 7.6cm)
shipping weight
2 lbs (0.9 kg)
operating temperature
–4°F to 131°F  (–20°C to 55°C)
A 
excluding channels 95 through 99