Epson 3010 Benutzerhandbuch

Problem Solving

■

Make sure the power cord is connected. Then wait a moment for the Ppower button to 
light up before pressing the Ppower button on the projector or the 

On

 button on the 

remote control.

■

If you’ve set the 

Control Panel Lock

, the control panel buttons are disabled; you must 

use the remote control to turn on the projector (see page 36).

■

If you’ve set the 

Child Lock

, you have to press the Ppower button on the projector for 3 

seconds to turn on the projector, or use the remote control (see page 36).

No Signal 

 

■

Press one of the 

Source

 buttons on the remote control, or press the 

Source

 button 

on the projector, to select the correct input source. Allow a few seconds for the projector 
to sync up after pressing the button.

■

Press the 

A/V Mute 

button on the remote control to make sure the picture hasn’t been 

turned off temporarily.

■

Check that the power light is on and not flashing, and the lens cover is off.

■

The projector may be in standby (or sleep) mode. If the Ppower button is lit and the 

power light is off, press the Ppower button to turn the projector back on. 

■

Make sure your video equipment is turned on.

■

Make sure your cable(s) are connected correctly (see page 18).

The temperature 
light flashes red

There is a fan or sensor problem. Turn off the projector and 
unplug it from the electrical outlet. Then contact Epson for 
assistance (see page 77).

Both warning 
lights are flashing 
red

There is an internal problem.

 

Turn off the projector and unplug it 

from the electrical outlet. Then contact Epson for assistance (see 
page 77).

pl3010_3010e_UG.book  Page 71  Wednesday, September 7, 2011  6:28 PM