Toshiba B-SX8T SERIES Benutzerhandbuch

ENGLISH VERSION EO1-33057 

5.3 Removing Jammed Media 

E5- 6 

8.  Release the Media Sensor Harness from the last Cable Clamp attached 

at the end of the Media Sensor Plate.  Then, remove the Media Guide 
Plate from the printer.  

 

 

 

9.  Remove jammed media from the media path.  DO NOT USE any 

sharp implements or tools as these could damage the printer

 

 

 
 

10.  Clean the Print Head and Platen, then remove any further dust or 

foreign substances.  

11.  Clean the Media Guides  (Refer to Section 4.1.3) 

12.  Paper jams in the Cutter Unit can be caused by wear or residual glue 

from label stock on the cutter.  Do not use non-specified media in 
the cutter.   

13.  Re-install the Media Guide Plate on the printer in the reverse order 

of removal.  At this time do not forget to fasten the Media Sensor 
Harness by the Cable Clamps.   

 

When fastening the harness by the centre Cable Clamp, place the 
blue and green harnesses over the yellow harness, and remove the 
slack of the harnesses, as shown in the picture below.   

 

 

Media Guide 
Plate

Cable Clamp

Media Sensor 
Harness

 

Media Path

Harness

(Yellow)

Harness (Blue)
Harness (Green)

Movable Media Sensor

Portion A

 

Media Guide Plate