2WIRE 502MX Merkblatt

PIB #  351305

To return the PDP-502MX plasma display to the default settings, follow the instructions below.  This
series of commands affects only the 

Picture

 settings.

1)   Set the PDP-502MX to the Standby mode.

2)  Wait until the small red light on the side of the panel stops blinking before proceeding.

3)  Press and release 

 on the remote control.

4)  Within three seconds, press 

 on the remote control.

It may take up to ten seconds for the Integrator Menu to appear.  The word, 

Picture

, is

highlighted in pink

 

on this menu.

5)  Press the Right Arrow button on the remote control once.

6)  Press the Up Arrow button on the remote control to highlight the word, 

Default

.

7) Press 

on the remote control.

8)  Press the Left Arrow button on the remote control to confirm the default setting.

9) Press SET again to confirm the change and return to the previous menu.

10) Press 

 on the remote control to exit the Integrator Menu.

Standby button

Menu button

Set button

Arrow buttons

For additional assistance please contact your Pioneer representative or refer to the website: