2WIRE F-116P Benutzerhandbuch
Alignment and Troubleshooting
4-46
4) JAM 2
Description : 1. Recording paper is jammed in front of or inside the fuser.
2. Recording paper is stuck in the discharge roller and in the fuser just after
passing through the Actuator-Feed.
2. If the paper is
rolled in the Fuser Roller:
3. Paper is accordion in the fuser.
1. If the paper is
completely fed out of the printer,
but Jam 2 occurs : Exit sensor is defective.
- After the paper is completely discharged, actuator
Exit should return to the original position to shut the
photo-sensor. Sometimes it takes longer
hour than it should and does
not return.
- This occurs when a Guide claw is broken
away or transformed.
- It occurs when the Spring of a Guide claw is broken
away or transformed.
- It occurs when the Heat-Roller or
Pressure-Roller is seriously
contaminated with
the toner.
Check if the exit sensor actuator is
defective.
- Check if the actuator exit is
deformed (Check if the lever part
is deformed in shape).
- Check whether burrs occur in the
assembly part of the actuator exit
or not and if the actuator is
smoothly operated.
- Check if foreign matter and wire
get caught in the actuator exit's
operation.
defective.
- Check if the actuator exit is
deformed (Check if the lever part
is deformed in shape).
- Check whether burrs occur in the
assembly part of the actuator exit
or not and if the actuator is
smoothly operated.
- Check if foreign matter and wire
get caught in the actuator exit's
operation.
If the paper is stuck in the fuser :
disassemble the fuser and remove
the jammed paper, and clean the
surface of the pressure roller with
dry gauze.
disassemble the fuser and remove
the jammed paper, and clean the
surface of the pressure roller with
dry gauze.
Remove the jammed paper after
disassembling the fuser : Clean
the surface of the pressure roller
with dry gauze.
- Remove the toner particles
stained on the rib.
- Check the assemblage and
performance of the exit.
disassembling the fuser : Clean
the surface of the pressure roller
with dry gauze.
- Remove the toner particles
stained on the rib.
- Check the assemblage and
performance of the exit.