Intel 8XC196MD Benutzerhandbuch
5-7
STANDARD AND PTS INTERRUPTS
When the level-sensitive event is selected, the external interrupt signal must remain asserted for
at least 24 T
at least 24 T
XTAL
1
(24/F
XTAL
1
) to be recognized as a valid interrupt. When the signal is asserted,
the level sampler samples the level of the signal three times during a 24 T
XTAL
1
period. When a
valid level occurs, the level sampler generates a a single output pulse. The output pulse generates
the EXTINT interrupt request. The level-sensitive mode is useful in noisy environments, where
a noise spike might cause an unintentional interrupt request.
the EXTINT interrupt request. The level-sensitive mode is useful in noisy environments, where
a noise spike might cause an unintentional interrupt request.
When an edge-triggered event is selected, the input must remain asserted for at least two T
XTAL
1
(2/F
XTAL
1
) to be recognized as a valid interrupt. When a valid transition occurs, the transition de-
tector generates a single output pulse. The output pulse generates the EXTINT interrupt request.
Figure 5-2. Waveform Generator Protection Circuitry
5.3.3
Multiplexed Interrupt Sources
The PI (MD), OVRTM (Mx), and SPI (MH) interrupts have multiple sources (see Table 5-3 on
page 5-5). An individual source will generate the interrupt only if software enables both the in-
terrupt source and multiplexed interrupt. To enable the multiplexed interrupt, set the appropriate
bit in the interrupt mask register (Figures 5-7 and 5-8). To enable an interrupt source, set the ap-
propriate bit in the PI_MASK register (Figure 5-9 on page 5-17). Figure 5-3 shows the flow for
the timer interrupt.
page 5-5). An individual source will generate the interrupt only if software enables both the in-
terrupt source and multiplexed interrupt. To enable the multiplexed interrupt, set the appropriate
bit in the interrupt mask register (Figures 5-7 and 5-8). To enable an interrupt source, set the ap-
propriate bit in the PI_MASK register (Figure 5-9 on page 5-17). Figure 5-3 shows the flow for
the timer interrupt.
NOTE
Although the PI interrupt on the 8XC196MC has a single source (the
waveform generator), software must still enable both the source interrupt
(WG) in the PI_PEND register and the PI interrupt in the INT_MASK register.
waveform generator), software must still enable both the source interrupt
(WG) in the PI_PEND register and the PI interrupt in the INT_MASK register.
A2661-01
EO Bit
Register
Transition
Detector
Q
Pulse
DP
R
S
00
01
10
11
Falling
Rising
Low
High
OD#
ES, IT
CPU Read EO
CPU Write EO
CPU Bus
EXTINT
Interrupt
Request
Request
Level
Sampler
EXTINT
F
XTAL1