Sterling SSE-5 BL Benutzerhandbuch
SSE 5 BL
Error and error correction 7
If a disturbance occurs in the unit, an alarm message will be issued (option, only if the alarm
indicating device has been activated).
indicating device has been activated).
&
An “E” appears in the display and an error number.
The alarm indicating device (signal siren, horn) reacts.
F
The control system can only restart operation when the
malfunction has been corrected.
malfunction has been corrected.
Press the “acknowledgement key”.
&
The cause of the malfunction will not be corrected by pressing
the “acknowledgement key”.
the “acknowledgement key”.
The following error messages can be displayed:
“E1"
The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive
conveying cycles.
Check that sufficient material is being conveyed.
Check that the flap switch is set correctly.
The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive
conveying cycles.
Check that sufficient material is being conveyed.
Check that the flap switch is set correctly.
F
When the malfunction has been corrected press the key.
“E2"
If the control system becomes too hot during operation (>70°C, 158°F) the “E2" alarm message is
displayed and the unit is switched off.
Ensure that the control system is sufficient cooled.
If the control system becomes too hot during operation (>70°C, 158°F) the “E2" alarm message is
displayed and the unit is switched off.
Ensure that the control system is sufficient cooled.