BenutzerhandbuchInhaltsverzeichnisTable of Contents31 Safety instructions51.1 General safety instructions51.2 Environmental conditions51.3 Electrostatic Discharge (ESD)52 Product information62.1 General description62.2 Compatible transmitters62.3 Main applications7LE10 Radio Receiver as small stand alone call system7LE10 Radio Receiver connected to a emergency call system via relay contact7LE10 Radio Receiver as part of a Resident Alert System monitoring dementia72.4 Description of the different modes73 Installation93.1 Unpacking93.2 Connecting the power supply93.2.1 Power supply with the RJ12 power socket93.2.2 Power supply connected to a wired installation93.3 Wall installation104 Connection compartment114.1 Connecting ports114.2 Mode selection124.2.1 Mode indication after power on125 Programming135.1 Enter programming mode135.2 Program a transmitter in modes 1, 2 or 513Device behavior135.3 Delete a transmitter14To start deleting:14Device behavior145.4 Delete all transmitters14To start deleting14Device behavior145.5 Program a door address in modes 3 or 415Device behavior155.5.1 Programming in modes 6 or 7156 Operation166.1 Standby mode166.1.1 Standby with no transmitter programmed16Device behavior166.1.2 Standby with at least one transmitter programmed16Device behavior166.2 Normal mode (modes 1 and 2)166.2.1 Activation of a transmitter in normal mode16Device behavior16Device behavior when a transmitter has a low battery16Device behavior when the battery is replaced in a transmitter176.3 Dementia (mode 3)176.3.1 Activation of a MIYS37L Wristband Transmitter17Device behavior17Device behavior when a MIYS37L transmitter has a low battery176.3.2 Detection of a MIYS37E Wristband Transmitter alone18Device behavior186.3.3 Detection of a MIYS37L Wristband Transmitter with a MIYS37E Wristband Transmitter nearby18Device behavior186.4 Dementia with Accompany (mode 4)196.4.1 Activation of a MIYS37L Wristband Transmitter19Device behavior196.5 Remote control (mode 5)196.5.1 Activation of a programmed transmitter19Device behavior196.5.2 Activation of a programmed transmitter with a battery-low message or with a new battery206.6 Open receiver (modes 6 and 7)206.6.1 Activation of a transmitter in the reception range20Device behavior206.7 Daily messages in modes 1, 2 or 5206.7.1 Daily message with battery-low signal20Device behavior206.7.2 Reset of a battery-low indication with button T121Device behavior216.8 Extended MIYN46 (mode 8, only with SW 1.10)21Standby21When a MIYS37 transmitter, MIYS35 transmitter, MIYRAC contact, MIYMD ManDown Sensor are activated:21When a MIYN46 transmitter’s red or blue button is pressed, or when one of its inputs is activated:21Battery-low indication:226.9 Dual channel receiver (mode 9, only with SW 1.10)22Standby22When a transmitter, that is matched on a odd position (1, 3, 5, etc.), is activated:22When a transmitter, that is matched on a even position (2, 4, 6, etc.), is activated:22Battery low indication (until the battery is exchanged)227 Technical data23Größe: 656 KBSeiten: 24Language: EnglishHandbuch öffnen
