Benutzerhandbuch für EchoStar 44

Inhaltsverzeichnis

• DISH Pro Plus 44 Multi-Dish Switch

  1
• Installation Guide

  1
  • Important Safety Instructions

    2
    • 1. Read these instructions.

      2
    • 2. Keep these instructions.

      2
    • 3. Heed all warnings.

      2
    • 4. Follow all instructions.

      2
    • 5. Use only attachments/accessories specified by the manufacturer.

      2
    • 6. Refer all servicing to qualified personnel.

      2
  • Contents

    4
  • Introduction

    5
  • Features

    5
  • Installation Instructions

    6
    • Mounting and Connecting the Switch

      6
      • 1. Mount the DISH Pro Plus 44 switch onto the side of a building, or on some other sturdy structure. Make sure that the mounting location is stable, and that you fasten the switch tightly to the surface.

        6
  • Figure 1. Mounting the Switch

    8
    • 2. Connect the coaxial cables from the LNBFs in your system to the ports on the switch labeled To Dish (see also the wiring diagrams that begin on page 17).

      8
    • 3. Connect a cable between To Power Inserter 1 connection on the switch and the power inserter marked To Switch Input 1.

      9
    • 4. Connect the cables from the receiver’s back panel Satellite In port(s) to the To Receiver Satellite In port of the power inserter installed in the previous step, or to switch ports Ç through Ñ labeled To Receiver Satellite In.

      10
      • a. Connect a cable from a To Receiver Satellite In port on either the switch or power inserter to the DISH Pro Plus Separator.

        10
      • b. Connect cables between the receiver Satellite In 1 and Satellite In 2 to ports 1 and 2 respectively on the DISH Pro Plus Separator.

        10
      • 4. Make sure all connections are secure.

        10
      • 5. Plug the power supply for the power inserter into a power outlet.

        10
    • Run Check Switch

      11
      • 1. Open the Point Dish/Signal Strength screen. See your DISH Network satellite receiver user’s guide for instructions. A Point Dish/Signal screen similar to the one shown as Figure 2 will open.

        11
  • Figure 2. Point Dish Screen

    11
    • 2. Select Check Switch or Test, depending on your receiver model. The Check Switch screen will open. Select Check or Test, depending on your receiver model.

      12
    • 3. The Check Switch procedure will run. When it finishes, you will see an Installation Summary screen.

      12
  • Figure 3. DISH Pro Plus Installation Summary

    12
  • Figure 4. Non-DISH Pro Installation Summary

    13
  • Figure 5. Non-DISH Pro Installation Summary

    14
    • 4. If you do not see the information as described in step 3 of this procedure, you will need to check all cables and switches, a...

      15
    • Adding More Switches

      15
    • Wiring Diagrams

      16
  • Figure 6. DISH Pro Plus 44 Connections

    16
  • Figure 7. Additional DISH Pro Plus 44 Switches

    17
    • Limited Warranty

      18
      • Advance Exchange Program

        20
      • Post Receipt Exchange Program

        21
      • Accessory Warranty

        21
    • If You Need Help

      22
    • FCC Rules

      23
    • UL Information

      23