BenutzerhandbuchInhaltsverzeichnisStorage Precautions8Daily storage procedure8Long-term storage procedure8Operating the helicopter after long-term storage8Other Types of Management8Transfer of product8Disposal of product8Export control8About Warranty9Inspection Types and Descriptions9Pre-flight inspection9Post-flight inspection930-hour free inspection9Periodic inspection9Engine10Starter motor does not operate.10Unable to start the engine10Engine speed does not increase10Engine lacks power10Engine overheating10Coolant gushed out of the recovery tank10Helicopter emits a burning smell10Engine idle is unstable10Engine idle is too high10Engine speed does not decrease after landing10Exhaust emits excessive smoke10Engine emits noise10Engine loses oil10Helicopter10Helicopter vibrates10Helicopter cannot take off10Helicopter makes noise during takeoff10Helicopter descends after takeoff10Helicopter moves considerably after takeoff10Helicopter drifts in one direction10Helicopter descends when flare (brake) is applied10when flare (brake) is applied10Warning Lamp Indications10Warning lamp illuminates or flashes10even after refueling10Speed Control10Speed control is unusable10When speed control is used, the helicopter moves arbitrarily10Flight Transmitter10Power lamp and battery lamp (green) do not illuminate10Transmitter battery state-of-charge warning10Transmitter battery’s usable range is too short10Dropped the transmitter on the ground10Dropped the transmitter in water10The sprayer cannot be turned ON or OFF at the flight transmitter.10The transmitter sounded 4 beeps repeatedly.10Sprayer10Liquid sprayer problems10Granular sprayer problems1030-hour free inspection9Helicopter antenna inspection7Helicopter exterior parts (names)3Helicopter interior parts (names)3Basic requirements1Helicopter requirements1Chemical requirements1Main head area inspection7Chemical tank4Control panel3inspection4flight lamp3installation and removal4main switch3starter switch3Coolant inspection7Oil inspection7Operator requirements1Data List2Dimensions2Periodic inspection9Drive shaft inspection7Post-flight cleaning and servicing6non-washable areas6washable areas6Electrical system inspection7periodic inspection4Starting5Stopping5disposal8Export control8transfer8Product safety label locations1Proper management8Flight modes5daily storage procedure8Flight requirements1long-term storage procedure8Flight transmitter3basic operation3long-term storage8battery monitor lamp3battery replacement4battery storage4charging the battery4checking radio signal interference4engine stop switch3radio signal distance test4flight switch3GPS switch3inspection7Safe functions during failsafe mode3rotor brake switch3Self monitor3spray switch3Servo inspection7Side cover installation and removal4helicopter movement3battery charging and replacement4helicopter movement3Flying precaution5Frequency settings and checks3Tail body area inspection7Fuel and refueling4Tail rotor inspection4Fuel inspection7Takeoff precautions and checks5Transporting the helicopter4General aerial application pattern5installation and removal4transporting4becomes poor3Warranty9warning lamp3Größe: 618 KBSeiten: 38Language: EnglishHandbuch öffnen
