Benutzerhandbuch für MTD 20

Benutzerhandbuch (English, Français)

Benutzerhandbuch

Inhaltsverzeichnis

NOTE: This operator’s manual covers various models of mowers. Follow instructions pertaining to your unit only.
6
NOTE: Reference to right, left, front or back of the lawn mower is from the operating position only, unless otherwise stated.
6
NOTE: Locknuts cannot be threaded onto a bolt by hand, a wrench is required for assembly. This type of nut is used where vibrations occur.
6
- Figure 1
  6
- Figure 2
  7
- Figure 3
  7
- Figure 4
  7
NOTE: If the blade control handle got displaced either during shipping or during assembly of other two handles, reassemble it now. If the blade control handle is firmly secured in place, you may proceed to the next assembly.
7
- Figure 5
  7
NOTE: The hole in the blade control handle must be on the left side and the control handle must touch the upper handle when squeezed.
7
- Figure 6
  8
- Figure 7
  8
NOTE: The holes provide three cutting heights for your mower. Use the same hole location for all four wheels when assembling. For example, if you desire the lowest cutting position, assemble each wheel at the highest hole on the deck.
8
- Figure 8
  8
- Figure 9
  9
NOTE: Make certain all nuts and bolts are tightened securely.
9
- Figure 10
  9
NOTE: If the starter rope becomes disconnected from rope guide on handle, disconnect and ground the spark plug wire. Depress the...
9
- Figure 11
  9
- Figure 12
  10
NOTE: The blade control handle must be depressed in order to operate the unit. Release the blade control handle to stop the engine and blade.
10
- Figure 13
  11
NOTE: We do not recommend the use of pressure washers or garden hose to clean your unit. These may cause damage to electric components, spindles, pulleys, bearings, or the engine. The use of water will result in shortened life and reduce serviceability.
12
- Figure 14
  12
NOTE: Improper blade balance will result in excessive vibration causing eventual damage to the engine and mower. Be sure to care...
12
NOTE: Always remove blade from the adapter for testing balance.
12
NOTE: Cutting grass in sandy soil condition causes abrasive wear to the blade.
13
NOTE: When storing any type of power equipment in a poorly ventilated or metal storage shed, care should be taken to rust-proof ...
13
NOTE: Be careful not to bend or kink cables.
13
NOTE: If the starter rope becomes disconnected from rope guide on handle, disconnect and ground the spark plug wire. Depress the...
13

Benutzerhandbuch

Größe:

3,53 MB
Seiten:

36
Languages:

English, Français

Handbuch öffnen