Benutzerhandbuch für MTD 428C

Inhaltsverzeichnis

• NOTE: This operator’s manual covers various models of tillers. The units illustrated may vary slightly from your unit. Follow only those instructions which pertain to your model number.

  5
• NOTE: References to right or left side of the tiller are determined from behind the unit in the operating position.

  5
• NOTE: All hardware needed for assembly is attached to the loose parts or the tiller.

  5
  • Figure 1

    5
  • Figure 2

    5
  • Figure 3

    6
  • Figure 4

    6
  • Figure 5

    6
  • Figure 6

    6
  • Figure 7

    7
• NOTE: Do not overtighten clutch cable, since too much tension may cause it to break.

  7
• NOTE: Keep hands out of belt area while unit is operating.

  7
• NOTE: If additional adjustment is required, it may be necessary to remove the belt cover and move the hex nuts at the other end of the clutch cable to increase belt tension.

  7
  • Figure 8

    8
• NOTE: If difficulty is encountered in moving the gear selection handle, refer to the following helpful hints:

  8
• NOTE: When pushing the unit with the engine off, you will hear a ratcheting sound (gear noise) which is normal.

  10
• NOTE: A warm engine may not require choking or to be primed.

  10
• NOTE: See your engine manual packed with your unit for more detailed instructions.

  10
• NOTE: After starting and prior to using the tiller for the first time, be certain to check the clutch adjustment as described in “Checking the Clutch Adjustment” section of the Assembly Instructions.

  10
• NOTE: After the first ten hours of operation, recheck the clutch adjustment. Refer to final clutch adjustment in Assembly Instructions.

  10
  • Figure 9

    11
• NOTE: Make certain the gear selection indicator is correctly positioned before engaging the clutch handle. If it is between gears, the engine will stall.

  11
• NOTE: Upon reassembly, make certain the belt is routed over the idler pulley and inside of belt keepers by engine pulley. See Figure 10.

  14
  • Figure 10

    14
• NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment and especially any springs, bearings, and cables.

  14
• NOTE: For repairs beyond the minor adjustments above, contact your local authorized service dealer.

  15