Accusplit EAGLE 1120 Leaflet

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should fit 

snugly and level, above one knee. 

 The pedometer should be as vertical as possible. Walkers 

with larger stomachs may find it helpful to wear the pedometer 

farther back on the body, toward one hip. 

To avoid losing or dropping your pedometer, use the included 

leash and clip to fasten the pedometer securely to your clothing. 

Attaching the Leash: Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, clasp 

the waist-band of your clothing with the attached clip. You can 

also use a safety pin to fasten the leash to your clothing, loop 

the leash through your belt or belt loop or use a badge holder. 

ACCUSPLIT, Inc.  •  2290M Ringwood Ave.  •  San Jose, CA 95131

800-965-2008  •  925-226-0888  •  FAX 925-463-0147    www.ACCUSPLIT.com   •  support@ACCUSPLIT.com

ACCUSPLIT®
       EAGLE

™

 

Congratulations on taking the first step to wellness with your purchase of an 

ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

Most people prefer to reset step counts daily. To \reset:  

Press and hold RESET button for at least three seconds to  

reset to zero. 

1. To filter out random movements, the unit remains in standby  

  mode until 5 continuous steps are registered. Only then are  

  the 5 steps calculated in, and an Active indicator “▲”  

  appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the  

  timer pauses and the unit switches to standby status (Active  

  indicator “▲” disappears). 

When the display starts to dim or goes blank, it is time to 

replace the battery. Your pedometer uses one Type L1142 

(LR43) 1.5 volt silver oxide battery. To replace: 

1. Using a jeweler’s screwdriver, loosen small screw  

  on back of unit. Remove back of case.
2. Slide the old battery gently out of its holder. Replace it with  

  a new battery. The battery’s positive (+) terminal should be  

  FACE UP while you put it into the pedometer.
3. Gently press front and back of pedometer case back  

  together, being sure to line up slots and tabs at top and  

  bottom of unit.

ACCUSPLIT

AccuSTEP

EAGLE

RESET

Once you put on your pedometer, it will automatically begin to 

record your steps. 

970-042

(Badge holder  

not included)

Refurbish, repair-or-replace service before 10/1/10, $5 fee; After 10/1/10, 

service may not be available. Return with fee and day phone # to:  

AST Repair Center/970-1010, 2290M Ringwood Ave., San Jose, CA 95131

REGISTER NOW 

Please return 

your AE1120 Registration to the 
Repair Center address in the 
warranty, and we will let you 
know about future products. 

Email (preferred)
User