Precor p20 User Manual

Assembling the AMT

Required Tools



⁵₁₆

-inch hex wrench



⁵₃₂

-inch hex wrench



#2 Phillips screwdriver



Rubber mallet



SAE standard socket set



Wire cutter



Torque wrench (calibrated in inch-pounds)

Performing the Assembly

DANGER

Do not attempt to connect electrical power until

all assembly procedures are complete and the

console is properly installed.

Follow these steps to assemble the AMT base unit.

To begin assembly:
1. Remove the two side fasteners that hold the front frame

tube to the shipping pallet and cut the tie wraps that

secure the rear base.

CAUTION: Do not move the AMT off its shipping pallet

without assistance. To avoid unnecessary movement of the

foot plates, do not install the handlebars until you begin the

next procedure.

2. Lift the rear base and roll the AMT forward while your

assistant stabilizes the front base and guides it off the

shipping pallet onto the floor.
Note: Begin assembly in the area intended for use.