Impex EVE-900 User Manual

 

A.)  Attach the 144” Lower Cable (#59) to the opening on the bottom of the Leg 

Developer (#9).  

B.)  Attach a Pulley (#41) to the opening. Secure it with one M10 x 2 ½” Allen Bolt 

(#64), two 

∅

 7/8” Pulley Bushings (#35), and one M10 Aircraft Nut (#81). 

C.)  Draw the Cable underneath the Pulley towards the back of the machine through 

the opening on the bottom of the Main Base Frame (#1) to an open bracket.  

D.)  Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#65), 

two Ø ¾” Washers (#77), and one M10 Aircraft Nut (#81). 

E.)  Draw the Cable underneath the Pulley towards the back of the machine to the 

Pulley Bracket (#18) underneath the Main Base Frame.  

F.)  Attach a Pulley to the bracket. Secure it with one L-shaped Bracket (#23), one 

M10 x 2” Allen Bolt (#66), two 

∅

 ¾” Washers (#77), and one M10 Aircraft Nut 

(#81). 

G.)  Pull the Cable upward to the Angled Double Floating Pulley Brackets (#15) 

previously installed in Step 6. Repeat Step D to install another Pulley.  

H.)  Draw the Cable around the Pulley then pull downward to the open bracket on the 

Main Base Frame. Repeat Step D to install another Pulley. 

I.) 

Draw the Cable around the Pulley then pull upward to the Double Floating Pulley 
Bracket (#14) previously installed in Step-5. Repeat Step D to install a Pulley.  

J.)  Draw the Cable around the Pulley then pull downward to the bracket on the rear 

of Main Base Frame.  Attach the Cable to a 6-Joint Chain (#25) using a C-clip 
(#28).  Secure the other end of the Chain to the bracket with a M10 x 1” Allen 
Bolt (#72), two 

∅

 ¾” Washers (#77) and one M10 Aircraft Nut (#81). 

K.)  Use the length of the Chain to adjust the tension of the Cable Loop System.  If 

the Cables are too loose, shorten the Chain. 

L.)  Attach the 15-Joint Chain (#27) to the end of the Cable by using a C-clip. Attach 

the Arm Curl Handle (#12) to the Chain by using another C-clip. Replace Arm 
Curl Handle with the Ankle Strap (#82) for various Leg exercises. Adjust the 
length of Chain to obtain the desired exercise. Remove the Arm Curl Handle and 
Ankle Strap when using the Leg Developer.