Roland CD-2e User Manual
29
Advanced Uses
Recording
Listening
Deleting
Creating a CD
Editing an SD
Appendices
Convenient
Functions
Information
/
Display
Checkin
g
/
Preparations
Preparing the Remote Control
Install a coin-type lithium battery (included) in the remote control.
fig.remote01-e.eps
* Use only the specified type (model no.CR2025) of lithium battery. Be sure to insert it as
directed to ensure correct polarity.
1
Pull out the battery holder.
2
Insert a lithium battery (CR2025) as shown in the illustration.
3
Replace the battery holder.
Push it inward until it clicks into place.
Point the remote control toward the CD-2e’s sensor, and operate it within the specified
operating range.
operating range.
When the remote sensor detects a remote control operation, the [ENTER] button will
blink.
blink.
fig.remote02-e.eps
* Even if the remote control is within range, it may not work if there is an obstruction between it
and the remote sensor, or if the angle is excessive.
* The battery life will depend on the conditions of use. When the battery runs down, the operating
angle will become narrower. Replace the battery if this occurs.
* If you won’t be using the remote control for an extended period of time, remove the battery.
* If a spotlight or other strong light is directed at the remote sensor, it will be less responsive.
Installing Batteries in the Remote Control
Using the Remote Control
Back side of the
remote control
remote control
1
2
Battery holder
Press here in the direction of the
arrow while you pull out the holder.
arrow while you pull out the holder.
Batteries to use:
Lithium battery
(CR2025)
Remote control operating range
Distance: 5 meters
Angle: 45 degrees or less
Angle: 45 degrees or less
Remote sensor
Transmitter
CD-2e_e.book 29 ページ ２００７年９月１０日 月曜日 午後８時５７分