Chief Manufacturing JWP-V User Manual
Installation Instructions
JWP-V
14
CABLE MANAGEMENT
WARNING:
Make sure your cables do not run
through a pinch points. Do not put your fingers
between movable parts.
between movable parts.
For cable management (not shown), connect and
secure power/audio/video cables, making sure to
leave sufficient slack to allow for movement of the
display.
secure power/audio/video cables, making sure to
leave sufficient slack to allow for movement of the
display.
ADJUSTMENTS
Lateral Tension Adjustment
To adjust Lateral Tension:
1. Move arms laterally to check for desired tension.
2. Using a 3/16” hex wrench slightly tighten or loosen
lateral tension adjustment bolts (seeFigure 14).
3. Repeat Steps 1 and 2 until desired tension is
obtained.
Pitch Tension Adjustment
To adjust Pitch Tension:
1. Tilt display to check for desired tension.
2. If pitch tension in Centris Bracket requires
adjustment, perform the following steps:
d.
Remove Display from Centris Bracket.
e.
Using a 3/16” hex wrench, slightly tighten or
loosen pitch adjustment bolt to adjust Centris
Bracket as needed (see Figure 15).
loosen pitch adjustment bolt to adjust Centris
Bracket as needed (see Figure 15).
f.
Reinstall display.
3. Repeat Steps 1 and 2 until desired tension is
obtained.
Figure 14. Adjust Lateral Tension
Figure 15. Adjust Pitch Tension
Pitch Adjustment Bolt
Lateral Tension Adjustment Bolt