Peerless Industries DS-VW760 User Manual

solid concrete

cinder block

VIDEO WALL  

MOUNT ASSEMBLY

•  When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual

concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount 

in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM

C-90 specifications. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a

hammer drill to avoid breaking out the back of the hole when entering a void or cavity.

•  Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
•  Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware

and components.

wall 

plate

wall 

plate

plaster/

dry wall

plaster/

dry wall

concrete

concrete

Drill holes and insert anchors (

F).

Place plate (

A) over anchors (E) and secure with screws (F).

Tighten all fasteners.

concrete 

surface

•  Tighten screws so that wall plate is firmly attached,

but do not overtighten. Overtightening can damage

screws, greatly reducing their holding power.

•  Never tighten in excess of 80 in. • lb (9 N.M.).
•  Always attach concrete expansion anchors directly 

to load-bearing concrete.

•  Never attach concrete expansion anchors to

concrete covered with plaster, drywall, or other 

finishing material. If mounting to concrete surfaces

covered with a finishing surface is unavoidable,

the finishing surface must be counterbored as

shown below. Be sure concrete anchors do not 

pull away from concrete when tightening screws. If 

plaster/drywall is thicker than 5/8" (16 mm), custom

fasteners must be supplied by installer

Make sure that video wall mount assembly is level, 

use it as a template to mark four mounting holes. 

Drill four 1/4” (6 mm) dia. holes to a minimum depth

of 2.5” (64 mm). Insert anchors (

F) in holes flush

with wall as shown (right). Place video wall mount

assembly over anchors and secure with four #14 

x 2.5” screws (

E), and fender washers (G). Level,

then tighten all fasteners.

ISSUED: 04-23-10   SHEET #: 145-9010-2  04-27-10